To schedule CNC machine time at AWPL, you must email Alan Harp alan.harp@coa.gatech.edu for your time to be logged into the chart below. The chart will be updated daily.

This chart is also for scheduling program verification time with Alan Harp prior to actual CNC machining. After 4:00 pm times are for scheduling CNC time with other professors.

Note: If your programs are not correct, you may have to reschedule actual cutting time.

You must be in a scheduled AWPL course or AWPL associated course to gain access to the CNC machine.

Maximum time blocks are 2 hours unless you have prior approval from Alan.

If you do not show up at your scheduled time, you can be "bumped" immediately by anyone waiting to run parts. You then must reschedule a new time/get in the back of the line.

At the end of your machining operations, you are required to clean up all dust and debris from the CNC machine and surrounding area.

Failure to clean up will result in loss of machining privileges.

The times listed are the beginning times of that scheduled slot. ex: 8am = 8:00am-8:59am.

Furn = Senior Studio Furniture Design

Vent = Daniel Baerlecken / Ventulett Display System

Wall = Daniel Baerlecken/ Gernot Riether Wall System

N/A = Not available